Use these LED mounting clips to hold your 3mm LED or 5mm LED in place when there is not any way to tape/glue the LED from the backside.
There are some uses for LEDs where these can come in very handy. Like in RC vehicle bodies, or control panels.
Drill Bit Sizes:3mm LED or 5mm LED Mounting clips 10 Pack
Work great when you can get them inserted into the hole properly- I ordered 10 more than I expected to need and still ran out because so many of them bent during the installation- perhaps if the additional electronics were mounted further away from the base of the led and if the heat shrink tubing was slightly further away from the base of the led the legs would fit better into the clips and they might have been easier to install ( and just to be honest about this I thought I might have problems so I oversized my holes one additional drill size and I still had problems- perhaps if I try this again I might try countersinking the holes as well as deburring them
Can't thank you enough for fixing my error when I ordered the mounting clips for 3mm leds. Thank you so much.
Provides secure mount for the 3mm LEDs! gives the lights a nice trim look when not in use, too.
I needed 5mm clips. Unfortunately I did not notice the selector for clip size and got 3m by default. My mistake.
Hi KirkI am sorry to hear you got the incorrect size on the clips.If you had gotten LEDs at the same time as the clips we might have been able to catch that and ask you about the size.But the only item in your order WAS the clips so we had no way to check for you.Since you mentioned there was a default on the page, we have updated this page to make Select the default, so it is easier to be sure to get the right size.
Shelly
Subscribe today and get 10% off your first purchase
